Caps
Caps are used to be inserted in the head of Allen Head bolt. These are used where a customer prefers to keep debris, weld splatter, paint, etc out of the head so when popping our caps off will provide a clean wrench area for fast bolt removal or part adjustment.
Trunnions
Base Plate
Backbones
Blocks
Plates
Clamp Risers
Shims
Caps
Modify Product Filter Configration
|
Your Part Number is:
|
|||
| Unit Selection |
Metric
Inches
|
||
| Material |
1010 Full Hard
300 Series Stainless Steel
300 Series Stainless Steel
Blue Tempered
Brass
Aluminum
|
||
| Thickness |
1/8 mm
1/4 mm
1/2 mm
1 mm
2 mm
1/64
1/32
1/16
|
||
| Screw size |
|
Minimum: 1.4 Maximum: 24 |
|
| Length - D1 |
|
Minimum: S * 8 Maximum: 292 Increments: 1mm |
|
| Width - D2 |
|
Minimum: S * 4 Maximum: 290 Increments: 1mm | |
|
Your Part Number is:
|
|||
| Customer Specified Thickness | |||
Instructions
The videos and slide shows below will show you Why and When you would design in adjustability with precision shims in our product holding jigs and fixtures.
The videos demonstrate the use of RAPid Blocks™ RB00 and RB02. These blocks have many uses in weld fixtures and other product part holding machines. They are often used for precision adjustment of locating pins in a fixture as demonstrated below.
The PDF’s below show the the 32 different footprints you can create with versatility of RB00 and RB02.
Reviews
There are no reviews yet.